Fit and Tolerance – Page 2 – HI MCQ!

Which of the following is not a clearance fit?

Mark as favorite

– 25 – + 0.05?

Mark as favorite

A hole whose lower division is zero is called hole basis, which one of the following letters indicates basic hole?

Mark as favorite

The fit specifications 30H7/g6 corresponds to following?

Mark as favorite

The relation between the two part where one is inserted to the other with a certain degree of tightness or looseness is now as?

Mark as favorite

In ________ fit there is a positive allowance between the largest possible shaft and the smallest possible hole?

Mark as favorite

For basic size of shaft of diameter 20 mm H7 limit are 0 and 21 microns and for hole of same diameter, g6 limit are -7 and -20 microns, find the maximum clearance between hole and shaft.?

Mark as favorite

Which type of tolerance is provided in drilling mostly?

Mark as favorite

Which of the following fits is not according to the BIS system?

Mark as favorite

_______________ is the difference between the maximum limit of size and the minimum limit of size?

Mark as favorite