Which among the following instruments are use to check the components only to ensure that the size are within the prescribed limits in mass production work? Mark as favorite Copy Link dial test indicator try square vernier caliper gauge Check Answer
In shaft basis system? Mark as favorite Copy Link fundamental deviation of the hole is taken as zero fundamental deviation of the shaft is taken as zero the size of the shaft is kept constant and size of hole is varied both a and c Check Answer
limits of 30 mm hole is ES= +0.025 and EI= +0.002 mm. The maximum and minimum hole sizes will be? Mark as favorite Copy Link max. 30.02 mm ; min. 29.998 mm max. 30.025 mm ; min. 30.002 mm max. 29.998 mm ; min. 30.002 mm max. 29.990 mm ; min. 29.975 mm Check Answer
Which one of the following is the clearance fit under the hole basis system? Mark as favorite Copy Link 50 H7/p6 50 H7/z11 50 E8/g11 50 H7/g11 Check Answer
The size of a component is given as 29 -0.1. What does -0.1 indicate? Mark as favorite Copy Link upper deviation is +0.1 lower deviation is 0.0 fundamental deviation is 0.0 lower deviation is -0.1 Check Answer
In the BIS system of limits, the grade of tolerances are represented by number symbols and there are ______? Mark as favorite Copy Link 18 grades of tolerances 16 grades of tolerances 24 grades of tolerances 21 grades of tolerances Check Answer
If the dimension of a component is finished within the limits of size, then it will be a/an ____________? Mark as favorite Copy Link basic size minimum size acceptable size rejected size Check Answer
The quality control allows at the most 0.4% defective part how many defective part can be allowed in a production of 500 part? Mark as favorite Copy Link 0.02 0.2 2 20 Check Answer
A limit system in which hole is constant member and different fit are obtained by varying the size of the shaft is called? Mark as favorite Copy Link shaft basis system hole basis system interchangeable system none of the above Check Answer
_______ is used to prepare a flexible joint between two shaft at desired angle? Mark as favorite Copy Link cotter joint key joint knuckle joint none of the above Check Answer