62 questions in Fit and Tolerance - HI MCQ!

Which among the following instruments are use to check the components only to ensure that the size are within the prescribed limits in mass production work?

Mark as favorite

In shaft basis system?

Mark as favorite

limits of 30 mm hole is ES= +0.025 and EI= +0.002 mm. The maximum and minimum hole sizes will be?

Mark as favorite

Which one of the following is the clearance fit under the hole basis system?

Mark as favorite

The size of a component is given as 29 -0.1. What does -0.1 indicate?

Mark as favorite

In ________ fit there is a positive allowance between the largest possible shaft and the smallest possible hole?

Mark as favorite

For basic size of shaft of diameter 20 mm H7 limit are 0 and 21 microns and for hole of same diameter, g6 limit are -7 and -20 microns, find the maximum clearance between hole and shaft.?

Mark as favorite

Which type of tolerance is provided in drilling mostly?

Mark as favorite

Which of the following fits is not according to the BIS system?

Mark as favorite

_______________ is the difference between the maximum limit of size and the minimum limit of size?

Mark as favorite