Which of the following is not a function of headstock? Mark as favorite Copy Link transmission of energy from the main motor to the job to provide a solid base to the job that needs to be turned arrangement for the position of the job holding device to provide varying speed with the help of shaft gear and liver Check Answer
While facing a job in lathe, a pip left in the centre is caused due to? Mark as favorite Copy Link blunt tool carriage is not locked tool is not set in centre improper clamping of tool Check Answer
The body of a three-jaw chuck has three openings _____ apart to assemble the jaws and operate them? Mark as favorite Copy Link 120° 90° 60° 45° Check Answer
For turning long taper with a small taper angle, the method of taper turning employed is? Mark as favorite Copy Link offsetting the tailstock form tool plunging swivelling the compound slide combination of the lathe cross slide and the compound slide movement Check Answer
The sliding surface of the lathe bed is? Mark as favorite Copy Link Flame hardened Normalized Case hardened Tempered Check Answer
In a lathe, a follower study is fixed on the? Mark as favorite Copy Link saddle apron bed tail stock Check Answer
study rest pad of lathe accessories are made of which of the following materials? Mark as favorite Copy Link brass bronze lead silver Check Answer
Which type of feed is needed for facing operation in lathe? Mark as favorite Copy Link longitudinal cross both a and b none of the above Check Answer
combination chuck jaws may be operated as? Mark as favorite Copy Link either independently or together independently together none of these Check Answer
Which one of the following is the correct formula for taper ratio? Mark as favorite Copy Link D-d/l D-d/2l D+d/l D+d/2l Check Answer