Which of the following is non-linear circuit parameter? Mark as favorite Copy Link Wire wound resistor Transistor Inductance Condenser Check Answer
A non-linear network does not satisfy? Mark as favorite Copy Link both homogeneity as well as superposition condition homogeneity, superposition and associative conditions superposition condition homogeneity condition Check Answer
The peak value of a sine wave is 200 V. Its average value is? Mark as favorite Copy Link 282.8 V 200 V 141.4 V 127.4 V Check Answer
When two waves are in phase they have peak values at an interval of? Mark as favorite Copy Link 90 180 120 none of the above Check Answer
An ideal voltage source should have? Mark as favorite Copy Link zero source resistance infinite source resistance large value of e.m.f small value of e.m.f. Check Answer
For the same peak value, which of the following waves has the least mean value? Mark as favorite Copy Link sine wave square wave half wave rectified sine wave triangular waves Check Answer
Which of the following refers to a parallel circuit? Mark as favorite Copy Link The equivalent resistance is greater than any one of the resistors The current through any one element is less than the source current The current through each element is same The voltage across element is different Check Answer
Maximum power output is obtained from a network when the load resis tance is equal to the output resis tance of the network as seen from the terminals of the load. The above statement is associated with? Mark as favorite Copy Link Superposition theorem Maximum power transfer theorem Millman's theorem Thevenin's theorem Check Answer
In a parallel R-C circuit, the current ….. always the applied voltage? Mark as favorite Copy Link remains in phase with lags leads none of the above Check Answer
In series resonant ci inductance to its twice value and reducing capacitance to its half value bus? Mark as favorite Copy Link will change the impedance at resonance frequency IL will increase the selectivity of the circuit will change the maximum value of current at resonance will change the resonance frequency Check Answer